Fundamentals / Ontology Audio
Gain staging: clear levels, better decisions
Gain staging is setting the level between stages of your signal chain. The goal is useful headroom, not one universal meter reading.
Start at the recording, not the master fader
Play or sing the loudest part before recording. Adjust the interface input gain so unexpected peaks still have room. If the converter clips during capture, lowering the recorded clip afterward does not restore the lost waveform. Leave room rather than chasing the top of the meter.
Once the recording is in your session, distinguish clip gain, plugin input, plugin output, and channel fader. They may all change level, but they act at different points. A fader after an overloaded processor cannot undo distortion that processor already introduced.
Check the next processor
Some plugins behave differently depending on input level. Analog-modeled processors and saturation tools may deliberately add more distortion as you drive them. Clean digital processors often provide much more internal headroom. Read the plugin documentation rather than treating every input as an analog console.
There is no requirement that every track peak at −18 dBFS. Peak level, average level, and an analog-model reference are different measurements. A short drum transient and a sustained bass can share a peak reading while driving the same processor very differently.
Match the output before you judge
Loop a representative passage. Bypass a processor, then enable it. Adjust its output so both versions sound similarly loud. Otherwise a small loudness increase can masquerade as better tone, punch, or detail.
Check the whole chain, not just individual plugins. Several small output boosts can accumulate into an overloaded bus. Conversely, repeatedly reducing levels without a reason can make monitoring inconvenient. Keep the signal comfortable for each next stage.
Leave the final output clean
Many modern DAWs use floating-point processing internally, which can preserve signals above nominal full scale at some stages. That does not make overload harmless everywhere: converters, some plugins, and fixed-point exports still have limits. Confirm how your actual tools handle peaks.
Before exporting, inspect the final output and listen through loud sections. Leave mastering headroom appropriate to your delivery workflow; there is no single peak target that guarantees a good mix. Gain staging supports decisions. It does not replace them.
At your next session
- Check the loudest passage before recording.
- Inspect levels before and after nonlinear processors.
- Compare bypassed and processed signals at similar loudness.
- Check the final output and exported file for unwanted clipping.